Cisco CCNA Voice Certification Practice Apply Follow Exercise Observe Questions Concerns Queries Inquiries Issues ThoughtsIIUC Exam Examination Test
Izvor: KiWi
(Nova stranica: Test your knowledge of dial peers, codecs, Connect with Manager Specific, [http://www.virtualfitting.co.kr/xe/?document_srl=2106281&mid=QA&sort_index=regdate&order_type=desc cisco …) |
|||
| Redak 1: | Redak 1: | ||
| - | + | Check your familiarity with dial friends, codecs, Get in touch with Manager Convey, [http://www.best-answer.chipcleary.com/node/58458 cisco 3845 router] plus much more. This may enable you to put together with the Cisco CCNA Voice IIUC 640-460 examination.<br /><br />(Solutions are for the close )<br /><br />one) Which from the pursuing is chosen initially for an incoming dial peer?<br /><br />A) Answer-address B) incoming called-number C) destination-pattern D) pots port E) dial-peer 0<br /><br />two) What is needed to transform a G711ulaw phone to G729?<br /><br />A) Voice Termination sources B) Conferencing resources C) Converter means D) Transcoding assets E) Gateway resources F) Gatekeeper resources<br /><br />3) What is the maximum quantity of telephones are supported on Phone Supervisor Categorical?<br /><br />A) forty eight B) 28 C) 240 D) five hundred E) 30000 F) four<br /><br />four) What protocol demands being enabled on an ATA if a fax equipment is linked to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />What protocol needs for being enabled on an ATA if an analog phone is linked to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />Solutions: 1)B - incoming called-number would be the initially selection when matching incoming dial-peers<br /><br />two)D - Transcoding assets are required to convert G711ulaw to G729<br /><br />3)C - the most amount of phones supported on CME is 240 on the 3845 Cisco router (this has adjusted not too long ago to 250, nevertheless the CCNA Voice training course still sets this worth at 240)<br /><br />four)C - H323 desires to generally be enabled over the ATA if a fax equipment is connected to the ATA.<br /><br />5)B - SCCP needs being enabled about the ATA if an analog telephone is connected to the ATA.<br /><br />David Bombal,<br /><br />CCIE #11023, CCSI, CCDP, CCIP, CCNP, CCSP, CCVP, CCNA, CCDA<br /><br />David has in excess of ten years practical experience during the IT sector and has been training in the Cisco market for more than eight many years. He has labored with Cisco IP Telephony because the Phone Manager 3.0 days in 2001. | |
Inačica od 02:45, 8. siječnja 2014.
Check your familiarity with dial friends, codecs, Get in touch with Manager Convey, cisco 3845 router plus much more. This may enable you to put together with the Cisco CCNA Voice IIUC 640-460 examination.
(Solutions are for the close )
one) Which from the pursuing is chosen initially for an incoming dial peer?
A) Answer-address B) incoming called-number C) destination-pattern D) pots port E) dial-peer 0
two) What is needed to transform a G711ulaw phone to G729?
A) Voice Termination sources B) Conferencing resources C) Converter means D) Transcoding assets E) Gateway resources F) Gatekeeper resources
3) What is the maximum quantity of telephones are supported on Phone Supervisor Categorical?
A) forty eight B) 28 C) 240 D) five hundred E) 30000 F) four
four) What protocol demands being enabled on an ATA if a fax equipment is linked to the ATA?
A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931
What protocol needs for being enabled on an ATA if an analog phone is linked to the ATA?
A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931
Solutions: 1)B - incoming called-number would be the initially selection when matching incoming dial-peers
two)D - Transcoding assets are required to convert G711ulaw to G729
3)C - the most amount of phones supported on CME is 240 on the 3845 Cisco router (this has adjusted not too long ago to 250, nevertheless the CCNA Voice training course still sets this worth at 240)
four)C - H323 desires to generally be enabled over the ATA if a fax equipment is connected to the ATA.
5)B - SCCP needs being enabled about the ATA if an analog telephone is connected to the ATA.
David Bombal,
CCIE #11023, CCSI, CCDP, CCIP, CCNP, CCSP, CCVP, CCNA, CCDA
David has in excess of ten years practical experience during the IT sector and has been training in the Cisco market for more than eight many years. He has labored with Cisco IP Telephony because the Phone Manager 3.0 days in 2001.
