Cisco CCNA Voice Certification Practice Apply Follow Exercise Observe Questions Concerns Queries Inquiries Issues ThoughtsIIUC Exam Examination Test

Izvor: KiWi

(Usporedba među inačicama)
Skoči na: orijentacija, traži
Redak 1: Redak 1:
-
Check your familiarity with dial friends, codecs, Get in touch with Manager Convey, [http://www.best-answer.chipcleary.com/node/58458 cisco 3845 router]  plus much more. This may enable you to put together with the Cisco CCNA Voice IIUC 640-460 examination.<br /><br />(Solutions are for the close )<br /><br />one) Which from the pursuing is chosen initially for an incoming dial peer?<br /><br />A) Answer-address B) incoming called-number C) destination-pattern D) pots port E) dial-peer 0<br /><br />two) What is needed to transform a G711ulaw phone to G729?<br /><br />A) Voice Termination sources B) Conferencing resources C) Converter means D) Transcoding assets E) Gateway resources F) Gatekeeper resources<br /><br />3) What is the maximum quantity of telephones are supported on Phone Supervisor Categorical?<br /><br />A) forty eight B) 28 C) 240 D) five hundred E) 30000 F) four<br /><br />four) What protocol demands being enabled on an ATA if a fax equipment is linked to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />What protocol needs for being enabled on an ATA if an analog phone is linked to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />Solutions: 1)B - incoming called-number would be the initially selection when matching incoming dial-peers<br /><br />two)D - Transcoding assets are required to convert G711ulaw to G729<br /><br />3)C - the most amount of phones supported on CME is 240 on the 3845 Cisco router (this has adjusted not too long ago to 250, nevertheless the CCNA Voice training course still sets this worth at 240)<br /><br />four)C - H323 desires to generally be enabled over the ATA if a fax equipment is connected to the ATA.<br /><br />5)B - SCCP needs being enabled about the ATA if an analog telephone is connected to the ATA.<br /><br />David Bombal,<br /><br />CCIE #11023, CCSI, CCDP, CCIP, CCNP, CCSP, CCVP, CCNA, CCDA<br /><br />David has in excess of ten years practical experience during the IT sector and has been training in the Cisco market for more than eight many years. He has labored with Cisco IP Telephony because the Phone Manager 3.0 days in 2001.
+
Take a look at your familiarity with dial peers, codecs, Contact Supervisor Specific, [http://www.soupnbagel.co.kr/xe/bodex/2122639 3845 cisco ]  and a lot more. This tends to assist you to put together for your Cisco CCNA Voice IIUC 640-460 examination.<br /><br />(Responses are in the finish )<br /><br />1) Which in the pursuing is selected to start with for an incoming dial peer?<br /><br />A) Answer-address B) incoming called-number C) destination-pattern D) pots port E) dial-peer 0<br /><br />two) Exactly what is necessary to change a G711ulaw connect with to G729?<br /><br />A) Voice Termination resources B) Conferencing means C) Converter sources D) Transcoding sources E) Gateway means F) Gatekeeper means<br /><br />three) What's the utmost quantity of phones are supported on Connect with Supervisor Specific?<br /><br />A) 48 B) 28 C) 240 D) 500 E) 30000 F) four<br /><br />4) What protocol needs being enabled on an ATA if a fax equipment is linked to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />What protocol desires for being enabled on an ATA if an analog phone is linked to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />Responses: one)B - incoming called-number could be the initially choice when matching incoming dial-peers<br /><br />two)D - Transcoding assets are necessary to change G711ulaw to G729<br /><br />3)C - the maximum variety of phones supported on CME is 240 with a 3845 Cisco router (this has modified lately to 250, however the CCNA Voice class nonetheless sets this worth at 240)<br /><br />four)C - H323 wants to be enabled about the ATA if a fax machine is linked to the ATA.<br /><br />5)B - SCCP desires to be enabled on the ATA if an analog telephone is linked to the ATA.<br /><br />David Bombal,<br /><br />CCIE #11023, CCSI, CCDP, CCIP, CCNP, CCSP, CCVP, CCNA, CCDA<br /><br />David has above ten years experience within the IT market and it has been coaching inside the Cisco industry for over eight decades. He has labored with Cisco IP Telephony since the Simply call Manager 3.0 times in 2001.

Inačica od 02:46, 8. siječnja 2014.

Take a look at your familiarity with dial peers, codecs, Contact Supervisor Specific, 3845 cisco and a lot more. This tends to assist you to put together for your Cisco CCNA Voice IIUC 640-460 examination.

(Responses are in the finish )

1) Which in the pursuing is selected to start with for an incoming dial peer?

A) Answer-address B) incoming called-number C) destination-pattern D) pots port E) dial-peer 0

two) Exactly what is necessary to change a G711ulaw connect with to G729?

A) Voice Termination resources B) Conferencing means C) Converter sources D) Transcoding sources E) Gateway means F) Gatekeeper means

three) What's the utmost quantity of phones are supported on Connect with Supervisor Specific?

A) 48 B) 28 C) 240 D) 500 E) 30000 F) four

4) What protocol needs being enabled on an ATA if a fax equipment is linked to the ATA?

A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931

What protocol desires for being enabled on an ATA if an analog phone is linked to the ATA?

A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931

Responses: one)B - incoming called-number could be the initially choice when matching incoming dial-peers

two)D - Transcoding assets are necessary to change G711ulaw to G729

3)C - the maximum variety of phones supported on CME is 240 with a 3845 Cisco router (this has modified lately to 250, however the CCNA Voice class nonetheless sets this worth at 240)

four)C - H323 wants to be enabled about the ATA if a fax machine is linked to the ATA.

5)B - SCCP desires to be enabled on the ATA if an analog telephone is linked to the ATA.

David Bombal,

CCIE #11023, CCSI, CCDP, CCIP, CCNP, CCSP, CCVP, CCNA, CCDA

David has above ten years experience within the IT market and it has been coaching inside the Cisco industry for over eight decades. He has labored with Cisco IP Telephony since the Simply call Manager 3.0 times in 2001.

Dobavljeno iz "http://degiorgi.math.hr/kiwi/index.php/Cisco_CCNA_Voice_Certification_Practice_Apply_Follow_Exercise_Observe_Questions_Concerns_Queries_Inquiries_Issues_ThoughtsIIUC_Exam_Examination_Test"
Osobni alati