Cisco CCNA Voice Certification Practice Apply Follow Exercise Observe Questions Concerns Queries Inquiries Issues ThoughtsIIUC Exam Examination Test

Izvor: KiWi

(Usporedba među inačicama)
Skoči na: orijentacija, traži
Redak 1: Redak 1:
-
Exam your understanding of dial peers, codecs, Phone Manager Categorical, [http://www.gospelmallsupply.com/xe/?document_srl=537796 http://www.cisco3845.org/]  and even more. This will make it easier to get ready for that Cisco CCNA Voice IIUC 640-460 exam.<br /><br />(Responses are in the stop )<br /><br />one) Which on the subsequent is chosen first for an incoming dial peer?<br /><br />A) Answer-address B) incoming called-number C) destination-pattern D) pots port E) dial-peer 0<br /><br />2) Precisely what is required to convert a G711ulaw phone to G729?<br /><br />A) Voice Termination assets B) Conferencing methods C) Converter assets D) Transcoding methods E) Gateway methods F) Gatekeeper sources<br /><br />three) What exactly is the most range of telephones are supported on Connect with Supervisor Specific?<br /><br />A) forty eight B) 28 C) 240 D) 500 E) 30000 F) 4<br /><br />4) What protocol wants for being enabled on an ATA if a fax machine is connected to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />What protocol needs for being enabled on an ATA if an analog telephone is connected to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />Solutions: 1)B - incoming called-number could be the to start with selection when matching incoming dial-peers<br /><br />two)D - Transcoding resources are necessary to convert G711ulaw to G729<br /><br />3)C - the most variety of phones supported on CME is 240 over a 3845 Cisco router (this has improved a short while ago to 250, though the CCNA Voice training course however sets this value at 240)<br /><br />four)C - H323 requires for being enabled over the ATA if a fax equipment is linked to the ATA.<br /><br />five)B - SCCP desires to get enabled on the ATA if an analog phone is linked to the ATA.<br /><br />David Bombal,<br /><br />CCIE #11023, CCSI, CCDP, CCIP, CCNP, CCSP, CCVP, CCNA, CCDA<br /><br />David has more than ten years working experience inside the IT sector and has been instruction during the Cisco current market for over eight years. He has worked with Cisco IP Telephony since the Call Supervisor three.0 days in 2001.
+
Exam your knowledge of dial friends, codecs, Contact Supervisor Express, [http://ultramarinosteruel.com/content/3845-cisco-0 http://www.cisco3845.org/]  and a lot more. This can enable you to prepare for that Cisco CCNA Voice IIUC 640-460 examination.<br /><br />(Solutions are within the close )<br /><br />1) Which on the pursuing is chosen initially for an incoming dial peer?<br /><br />A) Answer-address B) incoming called-number C) destination-pattern D) pots port E) dial-peer 0<br /><br />two) What is necessary to change a G711ulaw simply call to G729?<br /><br />A) Voice Termination resources B) Conferencing sources C) Converter means D) Transcoding resources E) Gateway methods F) Gatekeeper resources<br /><br />3) Exactly what is the most variety of phones are supported on Get in touch with Supervisor Convey?<br /><br />A) forty eight B) 28 C) 240 D) five hundred E) 30000 F) 4<br /><br />4) What protocol demands being enabled on an ATA if a fax device is connected to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />What protocol requires being enabled on an ATA if an analog phone is connected to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />Solutions: 1)B - incoming called-number is the very first preference when matching incoming dial-peers<br /><br />two)D - Transcoding means are necessary to convert G711ulaw to G729<br /><br />three)C - the most variety of telephones supported on CME is 240 with a 3845 Cisco router (this has adjusted just lately to 250, although the CCNA Voice system even now sets this value at 240)<br /><br />four)C - H323 requires to become enabled to the ATA if a fax device is linked to the ATA.<br /><br />five)B - SCCP requires to be enabled to the ATA if an analog telephone is connected to the ATA.<br /><br />David Bombal,<br /><br />CCIE #11023, CCSI, CCDP, CCIP, CCNP, CCSP, CCVP, CCNA, CCDA<br /><br />David has above ten years practical experience in the IT marketplace and has been instruction from the Cisco industry for over eight decades. He has worked with Cisco IP Telephony for the reason that Phone Supervisor three.0 days in 2001.

Inačica od 03:47, 8. siječnja 2014.

Exam your knowledge of dial friends, codecs, Contact Supervisor Express, http://www.cisco3845.org/ and a lot more. This can enable you to prepare for that Cisco CCNA Voice IIUC 640-460 examination.

(Solutions are within the close )

1) Which on the pursuing is chosen initially for an incoming dial peer?

A) Answer-address B) incoming called-number C) destination-pattern D) pots port E) dial-peer 0

two) What is necessary to change a G711ulaw simply call to G729?

A) Voice Termination resources B) Conferencing sources C) Converter means D) Transcoding resources E) Gateway methods F) Gatekeeper resources

3) Exactly what is the most variety of phones are supported on Get in touch with Supervisor Convey?

A) forty eight B) 28 C) 240 D) five hundred E) 30000 F) 4

4) What protocol demands being enabled on an ATA if a fax device is connected to the ATA?

A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931

What protocol requires being enabled on an ATA if an analog phone is connected to the ATA?

A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931

Solutions: 1)B - incoming called-number is the very first preference when matching incoming dial-peers

two)D - Transcoding means are necessary to convert G711ulaw to G729

three)C - the most variety of telephones supported on CME is 240 with a 3845 Cisco router (this has adjusted just lately to 250, although the CCNA Voice system even now sets this value at 240)

four)C - H323 requires to become enabled to the ATA if a fax device is linked to the ATA.

five)B - SCCP requires to be enabled to the ATA if an analog telephone is connected to the ATA.

David Bombal,

CCIE #11023, CCSI, CCDP, CCIP, CCNP, CCSP, CCVP, CCNA, CCDA

David has above ten years practical experience in the IT marketplace and has been instruction from the Cisco industry for over eight decades. He has worked with Cisco IP Telephony for the reason that Phone Supervisor three.0 days in 2001.

Osobni alati