Cisco CCNA Voice Certification Practice Apply Follow Exercise Observe Questions Concerns Queries Inquiries Issues ThoughtsIIUC Exam Examination Test

Izvor: KiWi

(Usporedba među inačicama)
Skoči na: orijentacija, traži
Redak 1: Redak 1:
-
Examination your expertise in dial peers, codecs, Phone Manager Categorical, [http://alumni.dsu.ac.kr/?document_srl=586058 cisco 3845 router]  and much more. This will assist you get ready for the Cisco CCNA Voice IIUC 640-460 exam.<br /><br />(Responses are in the close )<br /><br />one) Which from the adhering to is chosen initial for an incoming dial peer?<br /><br />A) Answer-address B) incoming called-number C) destination-pattern D) pots port E) dial-peer 0<br /><br />2) What on earth is needed to convert a G711ulaw contact to G729?<br /><br />A) Voice Termination methods B) Conferencing sources C) Converter assets D) Transcoding methods E) Gateway means F) Gatekeeper methods<br /><br />three) What on earth is the maximum number of phones are supported on Get in touch with Supervisor Categorical?<br /><br />A) forty eight B) 28 C) 240 D) five hundred E) 30000 F) four<br /><br />four) What protocol requires for being enabled on an ATA if a fax equipment is connected to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />What protocol requirements being enabled on an ATA if an analog telephone is linked to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />Solutions: 1)B - incoming called-number will be the very first alternative when matching incoming dial-peers<br /><br />two)D - Transcoding means are needed to convert G711ulaw to G729<br /><br />3)C - the most quantity of phones supported on CME is 240 with a 3845 Cisco router (this has altered lately to 250, although the CCNA Voice course however sets this value at 240)<br /><br />4)C - H323 desires to become enabled within the ATA if a fax device is linked to the ATA.<br /><br />5)B - SCCP requires to become enabled about the ATA if an analog telephone is linked to the ATA.<br /><br />David Bombal,<br /><br />CCIE #11023, CCSI, CCDP, CCIP, CCNP, CCSP, CCVP, CCNA, CCDA<br /><br />David has above 10 years expertise inside the IT sector and it has been instruction while in the Cisco market place for over 8 a long time. He has worked with Cisco IP Telephony because the Connect with Manager 3.0 times in 2001.
+
Take a look at your understanding of dial peers, codecs, Call Supervisor Express, [http://www.epapyrus.com/xe/index.php?mid=QnA_&listStyle=webzine&document_srl=1892272 cisco 3845]  plus more. This can make it easier to put together with the Cisco CCNA Voice IIUC 640-460 exam.<br /><br />(Answers are with the conclude )<br /><br />one) Which from the following is chosen 1st for an incoming dial peer?<br /><br />A) Answer-address B) incoming called-number C) destination-pattern D) pots port E) dial-peer 0<br /><br />2) What exactly is required to transform a G711ulaw connect with to G729?<br /><br />A) Voice Termination sources B) Conferencing sources C) Converter means D) Transcoding resources E) Gateway resources F) Gatekeeper assets<br /><br />three) Exactly what is the most quantity of telephones are supported on Simply call Manager Specific?<br /><br />A) 48 B) 28 C) 240 D) 500 E) 30000 F) 4<br /><br />four) What protocol wants to become enabled on an ATA if a fax machine is connected to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />What protocol requirements for being enabled on an ATA if an analog phone is linked to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />Answers: 1)B - incoming called-number is the to start with preference when matching incoming dial-peers<br /><br />two)D - Transcoding methods are required to change G711ulaw to G729<br /><br />3)C - the most number of telephones supported on CME is 240 with a 3845 Cisco router (this has improved not too long ago to 250, however the CCNA Voice training course still sets this benefit at 240)<br /><br />four)C - H323 desires to become enabled on the ATA if a fax machine is linked to the ATA.<br /><br />five)B - SCCP desires being enabled to the ATA if an analog phone is linked to the ATA.<br /><br />David Bombal,<br /><br />CCIE #11023, CCSI, CCDP, CCIP, CCNP, CCSP, CCVP, CCNA, CCDA<br /><br />David has above 10 years expertise from the IT marketplace and it has been instruction from the Cisco market for over eight years. He has labored with Cisco IP Telephony since the Connect with Manager 3.0 times in 2001.

Inačica od 05:24, 8. siječnja 2014.

Take a look at your understanding of dial peers, codecs, Call Supervisor Express, cisco 3845 plus more. This can make it easier to put together with the Cisco CCNA Voice IIUC 640-460 exam.

(Answers are with the conclude )

one) Which from the following is chosen 1st for an incoming dial peer?

A) Answer-address B) incoming called-number C) destination-pattern D) pots port E) dial-peer 0

2) What exactly is required to transform a G711ulaw connect with to G729?

A) Voice Termination sources B) Conferencing sources C) Converter means D) Transcoding resources E) Gateway resources F) Gatekeeper assets

three) Exactly what is the most quantity of telephones are supported on Simply call Manager Specific?

A) 48 B) 28 C) 240 D) 500 E) 30000 F) 4

four) What protocol wants to become enabled on an ATA if a fax machine is connected to the ATA?

A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931

What protocol requirements for being enabled on an ATA if an analog phone is linked to the ATA?

A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931

Answers: 1)B - incoming called-number is the to start with preference when matching incoming dial-peers

two)D - Transcoding methods are required to change G711ulaw to G729

3)C - the most number of telephones supported on CME is 240 with a 3845 Cisco router (this has improved not too long ago to 250, however the CCNA Voice training course still sets this benefit at 240)

four)C - H323 desires to become enabled on the ATA if a fax machine is linked to the ATA.

five)B - SCCP desires being enabled to the ATA if an analog phone is linked to the ATA.

David Bombal,

CCIE #11023, CCSI, CCDP, CCIP, CCNP, CCSP, CCVP, CCNA, CCDA

David has above 10 years expertise from the IT marketplace and it has been instruction from the Cisco market for over eight years. He has labored with Cisco IP Telephony since the Connect with Manager 3.0 times in 2001.

Dobavljeno iz "http://degiorgi.math.hr/kiwi/index.php/Cisco_CCNA_Voice_Certification_Practice_Apply_Follow_Exercise_Observe_Questions_Concerns_Queries_Inquiries_Issues_ThoughtsIIUC_Exam_Examination_Test"
Osobni alati