Cisco CCNA Voice Certification Practice Apply Follow Exercise Observe Questions Concerns Queries Inquiries Issues ThoughtsIIUC Exam Examination Test

Izvor: KiWi

(Usporedba među inačicama)
Skoči na: orijentacija, traži
 
(Nije prikazano 30 međuinačica)
Redak 1: Redak 1:
-
Exam your understanding of dial peers, codecs, Call Manager Categorical, [http://www.immigrantlegal.ca/3845-cisco-0 cisco 3845]  and much more. This tends to assist you get ready for the Cisco CCNA Voice IIUC 640-460 exam.<br /><br />(Answers are with the conclusion )<br /><br />one) Which on the following is chosen initial for an incoming dial peer?<br /><br />A) Answer-address B) incoming called-number C) destination-pattern D) pots port E) dial-peer 0<br /><br />two) What exactly is needed to convert a G711ulaw get in touch with to G729?<br /><br />A) Voice Termination methods B) Conferencing means C) Converter resources D) Transcoding means E) Gateway assets F) Gatekeeper sources<br /><br />3) What's the utmost number of telephones are supported on Connect with Manager Categorical?<br /><br />A) forty eight B) 28 C) 240 D) 500 E) 30000 F) four<br /><br />four) What protocol requirements to be enabled on an ATA if a fax device is linked to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />What protocol desires to get enabled on an ATA if an analog phone is linked to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />Solutions: 1)B - incoming called-number would be the 1st alternative when matching incoming dial-peers<br /><br />2)D - Transcoding methods are necessary to change G711ulaw to G729<br /><br />three)C - the maximum range of phones supported on CME is 240 on the 3845 Cisco router (this has changed recently to 250, although the CCNA Voice program nonetheless sets this value at 240)<br /><br />4)C - H323 needs to become enabled around the ATA if a fax device is linked to the ATA.<br /><br />5)B - SCCP needs to generally be enabled over the ATA if an analog telephone is linked to the ATA.<br /><br />David Bombal,<br /><br />CCIE #11023, CCSI, CCDP, CCIP, CCNP, CCSP, CCVP, CCNA, CCDA<br /><br />David has more than ten years practical experience during the IT sector and has been instruction within the Cisco market for more than 8 yrs. He has labored with Cisco IP Telephony for the reason that Phone Supervisor three.0 days in 2001.
+
Check your expertise in dial friends, codecs, Get in touch with Supervisor Express, [http://bizuh.com/Pilar56H/info/ cisco 3845]  plus much more. This will likely make it easier to prepare for the Cisco CCNA Voice IIUC 640-460 exam.<br /><br />(Answers are on the end )<br /><br />one) Which on the following is chosen initial for an incoming dial peer?<br /><br />A) Answer-address B) incoming called-number C) destination-pattern D) pots port E) dial-peer 0<br /><br />two) What exactly is required to transform a G711ulaw get in touch with to G729?<br /><br />A) Voice Termination resources B) Conferencing sources C) Converter means D) Transcoding assets E) Gateway methods F) Gatekeeper sources<br /><br />three) What on earth is the utmost quantity of telephones are supported on Get in touch with Manager Categorical?<br /><br />A) forty eight B) 28 C) 240 D) five hundred E) 30000 F) 4<br /><br />four) What protocol demands to generally be enabled on an ATA if a fax machine is linked to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />What protocol needs to become enabled on an ATA if an analog telephone is linked to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />Responses: one)B - incoming called-number is the first selection when matching incoming dial-peers<br /><br />2)D - Transcoding resources are necessary to convert G711ulaw to G729<br /><br />3)C - the most number of phones supported on CME is 240 with a 3845 Cisco router (this has transformed not too long ago to 250, although the CCNA Voice course still sets this worth at 240)<br /><br />4)C - H323 requirements to be enabled around the ATA if a fax device is linked to the ATA.<br /><br />five)B - SCCP requires for being enabled within the ATA if an analog telephone is linked to the ATA.<br /><br />David Bombal,<br /><br />CCIE #11023, CCSI, CCDP, CCIP, CCNP, CCSP, CCVP, CCNA, CCDA<br /><br />David has over a decade knowledge from the IT sector and has been schooling from the Cisco marketplace for more than eight a long time. He has labored with Cisco IP Telephony because the Get in touch with Supervisor 3.0 times in 2001.

Trenutačna izmjena od 06:56, 8. siječnja 2014.

Check your expertise in dial friends, codecs, Get in touch with Supervisor Express, cisco 3845 plus much more. This will likely make it easier to prepare for the Cisco CCNA Voice IIUC 640-460 exam.

(Answers are on the end )

one) Which on the following is chosen initial for an incoming dial peer?

A) Answer-address B) incoming called-number C) destination-pattern D) pots port E) dial-peer 0

two) What exactly is required to transform a G711ulaw get in touch with to G729?

A) Voice Termination resources B) Conferencing sources C) Converter means D) Transcoding assets E) Gateway methods F) Gatekeeper sources

three) What on earth is the utmost quantity of telephones are supported on Get in touch with Manager Categorical?

A) forty eight B) 28 C) 240 D) five hundred E) 30000 F) 4

four) What protocol demands to generally be enabled on an ATA if a fax machine is linked to the ATA?

A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931

What protocol needs to become enabled on an ATA if an analog telephone is linked to the ATA?

A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931

Responses: one)B - incoming called-number is the first selection when matching incoming dial-peers

2)D - Transcoding resources are necessary to convert G711ulaw to G729

3)C - the most number of phones supported on CME is 240 with a 3845 Cisco router (this has transformed not too long ago to 250, although the CCNA Voice course still sets this worth at 240)

4)C - H323 requirements to be enabled around the ATA if a fax device is linked to the ATA.

five)B - SCCP requires for being enabled within the ATA if an analog telephone is linked to the ATA.

David Bombal,

CCIE #11023, CCSI, CCDP, CCIP, CCNP, CCSP, CCVP, CCNA, CCDA

David has over a decade knowledge from the IT sector and has been schooling from the Cisco marketplace for more than eight a long time. He has labored with Cisco IP Telephony because the Get in touch with Supervisor 3.0 times in 2001.

Dobavljeno iz "http://degiorgi.math.hr/kiwi/index.php/Cisco_CCNA_Voice_Certification_Practice_Apply_Follow_Exercise_Observe_Questions_Concerns_Queries_Inquiries_Issues_ThoughtsIIUC_Exam_Examination_Test"
Osobni alati