Cisco CCNA Voice Certification Practice Apply Follow Exercise Observe Questions Concerns Queries Inquiries Issues ThoughtsIIUC Exam Examination Test

Izvor: KiWi

(Usporedba među inačicama)
Skoči na: orijentacija, traži
 
(Nisu prikazane 23 međuinačice)
Redak 1: Redak 1:
-
Examination your expertise in dial peers, codecs, Phone Manager Categorical, [http://alumni.dsu.ac.kr/?document_srl=586058 cisco 3845 router]  and much more. This will assist you get ready for the Cisco CCNA Voice IIUC 640-460 exam.<br /><br />(Responses are in the close )<br /><br />one) Which from the adhering to is chosen initial for an incoming dial peer?<br /><br />A) Answer-address B) incoming called-number C) destination-pattern D) pots port E) dial-peer 0<br /><br />2) What on earth is needed to convert a G711ulaw contact to G729?<br /><br />A) Voice Termination methods B) Conferencing sources C) Converter assets D) Transcoding methods E) Gateway means F) Gatekeeper methods<br /><br />three) What on earth is the maximum number of phones are supported on Get in touch with Supervisor Categorical?<br /><br />A) forty eight B) 28 C) 240 D) five hundred E) 30000 F) four<br /><br />four) What protocol requires for being enabled on an ATA if a fax equipment is connected to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />What protocol requirements being enabled on an ATA if an analog telephone is linked to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />Solutions: 1)B - incoming called-number will be the very first alternative when matching incoming dial-peers<br /><br />two)D - Transcoding means are needed to convert G711ulaw to G729<br /><br />3)C - the most quantity of phones supported on CME is 240 with a 3845 Cisco router (this has altered lately to 250, although the CCNA Voice course however sets this value at 240)<br /><br />4)C - H323 desires to become enabled within the ATA if a fax device is linked to the ATA.<br /><br />5)B - SCCP requires to become enabled about the ATA if an analog telephone is linked to the ATA.<br /><br />David Bombal,<br /><br />CCIE #11023, CCSI, CCDP, CCIP, CCNP, CCSP, CCVP, CCNA, CCDA<br /><br />David has above 10 years expertise inside the IT sector and it has been instruction while in the Cisco market place for over 8 a long time. He has worked with Cisco IP Telephony because the Connect with Manager 3.0 times in 2001.
+
Check your expertise in dial friends, codecs, Get in touch with Supervisor Express, [http://bizuh.com/Pilar56H/info/ cisco 3845]  plus much more. This will likely make it easier to prepare for the Cisco CCNA Voice IIUC 640-460 exam.<br /><br />(Answers are on the end )<br /><br />one) Which on the following is chosen initial for an incoming dial peer?<br /><br />A) Answer-address B) incoming called-number C) destination-pattern D) pots port E) dial-peer 0<br /><br />two) What exactly is required to transform a G711ulaw get in touch with to G729?<br /><br />A) Voice Termination resources B) Conferencing sources C) Converter means D) Transcoding assets E) Gateway methods F) Gatekeeper sources<br /><br />three) What on earth is the utmost quantity of telephones are supported on Get in touch with Manager Categorical?<br /><br />A) forty eight B) 28 C) 240 D) five hundred E) 30000 F) 4<br /><br />four) What protocol demands to generally be enabled on an ATA if a fax machine is linked to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />What protocol needs to become enabled on an ATA if an analog telephone is linked to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />Responses: one)B - incoming called-number is the first selection when matching incoming dial-peers<br /><br />2)D - Transcoding resources are necessary to convert G711ulaw to G729<br /><br />3)C - the most number of phones supported on CME is 240 with a 3845 Cisco router (this has transformed not too long ago to 250, although the CCNA Voice course still sets this worth at 240)<br /><br />4)C - H323 requirements to be enabled around the ATA if a fax device is linked to the ATA.<br /><br />five)B - SCCP requires for being enabled within the ATA if an analog telephone is linked to the ATA.<br /><br />David Bombal,<br /><br />CCIE #11023, CCSI, CCDP, CCIP, CCNP, CCSP, CCVP, CCNA, CCDA<br /><br />David has over a decade knowledge from the IT sector and has been schooling from the Cisco marketplace for more than eight a long time. He has labored with Cisco IP Telephony because the Get in touch with Supervisor 3.0 times in 2001.

Trenutačna izmjena od 06:56, 8. siječnja 2014.

Check your expertise in dial friends, codecs, Get in touch with Supervisor Express, cisco 3845 plus much more. This will likely make it easier to prepare for the Cisco CCNA Voice IIUC 640-460 exam.

(Answers are on the end )

one) Which on the following is chosen initial for an incoming dial peer?

A) Answer-address B) incoming called-number C) destination-pattern D) pots port E) dial-peer 0

two) What exactly is required to transform a G711ulaw get in touch with to G729?

A) Voice Termination resources B) Conferencing sources C) Converter means D) Transcoding assets E) Gateway methods F) Gatekeeper sources

three) What on earth is the utmost quantity of telephones are supported on Get in touch with Manager Categorical?

A) forty eight B) 28 C) 240 D) five hundred E) 30000 F) 4

four) What protocol demands to generally be enabled on an ATA if a fax machine is linked to the ATA?

A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931

What protocol needs to become enabled on an ATA if an analog telephone is linked to the ATA?

A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931

Responses: one)B - incoming called-number is the first selection when matching incoming dial-peers

2)D - Transcoding resources are necessary to convert G711ulaw to G729

3)C - the most number of phones supported on CME is 240 with a 3845 Cisco router (this has transformed not too long ago to 250, although the CCNA Voice course still sets this worth at 240)

4)C - H323 requirements to be enabled around the ATA if a fax device is linked to the ATA.

five)B - SCCP requires for being enabled within the ATA if an analog telephone is linked to the ATA.

David Bombal,

CCIE #11023, CCSI, CCDP, CCIP, CCNP, CCSP, CCVP, CCNA, CCDA

David has over a decade knowledge from the IT sector and has been schooling from the Cisco marketplace for more than eight a long time. He has labored with Cisco IP Telephony because the Get in touch with Supervisor 3.0 times in 2001.

Dobavljeno iz "http://degiorgi.math.hr/kiwi/index.php/Cisco_CCNA_Voice_Certification_Practice_Apply_Follow_Exercise_Observe_Questions_Concerns_Queries_Inquiries_Issues_ThoughtsIIUC_Exam_Examination_Test"
Osobni alati