Cisco CCNA Voice Certification Practice Apply Follow Exercise Observe Questions Concerns Queries Inquiries Issues ThoughtsIIUC Exam Examination Test

Izvor: KiWi

(Usporedba među inačicama)
Skoči na: orijentacija, traži
Redak 1: Redak 1:
-
Test your familiarity with dial friends, codecs, Connect with Supervisor Specific, [http://liverpool.lt/fokov/en/content/cisco-3845-router-supreme-power-little-bundle cisco 3845]  and a lot more. This will assist you to put together for your Cisco CCNA Voice IIUC 640-460 examination.<br /><br />(Solutions are on the end )<br /><br />1) Which of the next is chosen first for an incoming dial peer?<br /><br />A) Answer-address B) incoming called-number C) destination-pattern D) pots port E) dial-peer 0<br /><br />2) What on earth is necessary to transform a G711ulaw get in touch with to G729?<br /><br />A) Voice Termination sources B) Conferencing assets C) Converter means D) Transcoding sources E) Gateway means F) Gatekeeper assets<br /><br />three) Exactly what is the maximum number of phones are supported on Connect with Supervisor Express?<br /><br />A) forty eight B) 28 C) 240 D) 500 E) 30000 F) four<br /><br />4) What protocol demands to get enabled on an ATA if a fax equipment is connected to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />What protocol needs to get enabled on an ATA if an analog telephone is linked to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />Answers: one)B - incoming called-number is the initial choice when matching incoming dial-peers<br /><br />2)D - Transcoding means are needed to convert G711ulaw to G729<br /><br />3)C - the utmost amount of phones supported on CME is 240 on a 3845 Cisco router (this has transformed just lately to 250, however the CCNA Voice training course continue to sets this worth at 240)<br /><br />4)C - H323 desires to generally be enabled over the ATA if a fax device is connected to the ATA.<br /><br />five)B - SCCP requirements for being enabled within the ATA if an analog telephone is connected to the ATA.<br /><br />David Bombal,<br /><br />CCIE #11023, CCSI, CCDP, CCIP, CCNP, CCSP, CCVP, CCNA, CCDA<br /><br />David has around 10 years experience within the IT field and has been schooling from the Cisco market for more than eight yrs. He has worked with Cisco IP Telephony since the Connect with Supervisor 3.0 days in 2001.
+
Exam your understanding of dial peers, codecs, Phone Manager Categorical, [http://www.gospelmallsupply.com/xe/?document_srl=537796 http://www.cisco3845.org/]  and even more. This will make it easier to get ready for that Cisco CCNA Voice IIUC 640-460 exam.<br /><br />(Responses are in the stop )<br /><br />one) Which on the subsequent is chosen first for an incoming dial peer?<br /><br />A) Answer-address B) incoming called-number C) destination-pattern D) pots port E) dial-peer 0<br /><br />2) Precisely what is required to convert a G711ulaw phone to G729?<br /><br />A) Voice Termination assets B) Conferencing methods C) Converter assets D) Transcoding methods E) Gateway methods F) Gatekeeper sources<br /><br />three) What exactly is the most range of telephones are supported on Connect with Supervisor Specific?<br /><br />A) forty eight B) 28 C) 240 D) 500 E) 30000 F) 4<br /><br />4) What protocol wants for being enabled on an ATA if a fax machine is connected to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />What protocol needs for being enabled on an ATA if an analog telephone is connected to the ATA?<br /><br />A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931<br /><br />Solutions: 1)B - incoming called-number could be the to start with selection when matching incoming dial-peers<br /><br />two)D - Transcoding resources are necessary to convert G711ulaw to G729<br /><br />3)C - the most variety of phones supported on CME is 240 over a 3845 Cisco router (this has improved a short while ago to 250, though the CCNA Voice training course however sets this value at 240)<br /><br />four)C - H323 requires for being enabled over the ATA if a fax equipment is linked to the ATA.<br /><br />five)B - SCCP desires to get enabled on the ATA if an analog phone is linked to the ATA.<br /><br />David Bombal,<br /><br />CCIE #11023, CCSI, CCDP, CCIP, CCNP, CCSP, CCVP, CCNA, CCDA<br /><br />David has more than ten years working experience inside the IT sector and has been instruction during the Cisco current market for over eight years. He has worked with Cisco IP Telephony since the Call Supervisor three.0 days in 2001.

Inačica od 03:44, 8. siječnja 2014.

Exam your understanding of dial peers, codecs, Phone Manager Categorical, http://www.cisco3845.org/ and even more. This will make it easier to get ready for that Cisco CCNA Voice IIUC 640-460 exam.

(Responses are in the stop )

one) Which on the subsequent is chosen first for an incoming dial peer?

A) Answer-address B) incoming called-number C) destination-pattern D) pots port E) dial-peer 0

2) Precisely what is required to convert a G711ulaw phone to G729?

A) Voice Termination assets B) Conferencing methods C) Converter assets D) Transcoding methods E) Gateway methods F) Gatekeeper sources

three) What exactly is the most range of telephones are supported on Connect with Supervisor Specific?

A) forty eight B) 28 C) 240 D) 500 E) 30000 F) 4

4) What protocol wants for being enabled on an ATA if a fax machine is connected to the ATA?

A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931

What protocol needs for being enabled on an ATA if an analog telephone is connected to the ATA?

A) MGCP B) SCCP C) H323 D) SIP E) QSIG F) Q931

Solutions: 1)B - incoming called-number could be the to start with selection when matching incoming dial-peers

two)D - Transcoding resources are necessary to convert G711ulaw to G729

3)C - the most variety of phones supported on CME is 240 over a 3845 Cisco router (this has improved a short while ago to 250, though the CCNA Voice training course however sets this value at 240)

four)C - H323 requires for being enabled over the ATA if a fax equipment is linked to the ATA.

five)B - SCCP desires to get enabled on the ATA if an analog phone is linked to the ATA.

David Bombal,

CCIE #11023, CCSI, CCDP, CCIP, CCNP, CCSP, CCVP, CCNA, CCDA

David has more than ten years working experience inside the IT sector and has been instruction during the Cisco current market for over eight years. He has worked with Cisco IP Telephony since the Call Supervisor three.0 days in 2001.

Dobavljeno iz "http://degiorgi.math.hr/kiwi/index.php/Cisco_CCNA_Voice_Certification_Practice_Apply_Follow_Exercise_Observe_Questions_Concerns_Queries_Inquiries_Issues_ThoughtsIIUC_Exam_Examination_Test"
Osobni alati