How To Refinish A Vinyl Or Tile Foor Using Floor Finish

Izvor: KiWi

---

Trenutačna izmjena od 01:16, 30. svibnja 2013.

The following procedure is for reapplying applications to an completed floor or applying finish to a fresh floor. When finishing a brand new floor always follow the manufacturers tips for prepping the floor. You should always consult the flooring company on the kinds of finishes that are suitable for your ground. We recommend that you use a quality floor finish that's properly matched to your floor when completing any floor. Our on line floor finishing procedures would be the basic guidelines for finishing a floor. Today floor finish has become the alternative to old fashioned waxes. Floor end can give a ground an excellent resilient glow with no problems of traditional waxes.

Procedure: web address

Make sure that your ground has been prepared for finishing. Clean the floor eliminating the maximum amount of dirt and debris as you can. If the floor has more than 5 coats of finish we suggest stripping the floor first. Too many layers of finish can dull a floor. With time floor finish can yellow in color, if you see any yellowing on the floor we also suggest that you strip the floor first.

After the floor has been organized, vacuum or dust mop the floor to remove any dust. We suggest that you apply your dust mop with dust mop treatment to get rid of just as much dust as possible. Be sure to eliminate anything stuck to the floor, anything that is on the floor when you finish it will become part of the floor finish and you will have to remove your floor and begin again.

Make certain that the floor are you are finishing doesn't and won't have traffic moving through it for at the least 12 - 24 hours depending on the type of finish that your are using (see floor finish manufacturers requirements for curing and drying time). Use warning signs to be sure the area what your location is finishing is marked out so that everyone else knows the area.

Completing a ground requires the usage of two mop buckets. One ocean will be used to keep the finish cleaner wet and the other will be used to apply the ground finish. So that you can dump the finish simply after the work is complete line bucket is finished by the floor with an obvious garbage can liner.

Bucket 1/2 way is mopped by fill one up with water and the covered mop bucket 1/4 whole with floor finish. Dip your finish mop in to the water bucket and wring water doesn't get from the end and until the mop is moist. Next, drop the damp mop to the floor finish and shake before finish mop doesn't spill.

The best way to finish surfaces is to separate the floor into sections to make sure that the even level of floor finish is applied everywhere. Start applying the floor finish at the furthest corner from the entrance. Use floor finish to the baseboard area first (a block applicator can be a good instrument because of this job) working from the corner. Ensure the floor finish is going to the floor in a thin even coat.

After floor has been applied by you finish to the baseboard proceed to the open areas of the floor. Go the mop head in a figure eight movement overlapping cleaning sections by about an inch.

Allow ground dry, once you have applied the final equally to the complete area. The ground should seem sleek without raised parts or drip marks. Follow a floor finish manufacturers tips for drying time. Depending on the floor finish you could wish to apply more than one coat of floor finish, if that's the case, let the floor dry between layers. You may even wish to buff the floor among coats in order that the second coat adheres safer to the initial coat.

To maintain the new look of the floor finish it is possible to burnish with a burnishing floor station, again see the manufacturers recommendations for maintenance on your floor.

After 12 hours your floor should really be completely treated. Ground traffic are now able to continue.