Advice for updating my VW stereo system388716
Izvor: KiWi
So you've got your amplifier, sub-woofer, speakers and head unit for the Volkswagen. Now what? Installing a stereo in a car normally is not as daunting a challenge as it appears at first with those wires. On The Other Hand, some suggestions might help when approaching the job for the.
Whenever working on electrical devices, ensure everything is switched off to stop hurting yourself. Make sure you have correctly disconnected it by examining your dash.
Cleanly installing a stereo to the car is typically the trickiest and most timeconsuming sections of the setup procedure as a result of many wires running to the head and amplifier unit. Before beginning, be sure you understand the method to wire your amp, speakers and head unit because that info can actually save a real pain afterward.
The baggage compartment is easily the most logical spot to situate the amp. The amp will certainly be screwed by lots of people towards the back of the rear-seat to save space or simply twist it towards the bottom of the trunk. Either way works fine.
The whole back-seat folds down, creating a straightforward avenue to run wires through to the front of the automobile. It's also where you'll need to ground your amplifier. Seem beneath the bottom seat cushions in the back, you'll see the seatbelts are screwed in by a nut.
Open one-of the back-doors and furthermore you'll see a plastic panel to the ground. This is the location where you'll have to stay on wiring your stereo. The same holds true for the frontdoor. These blackplastic panels could be removed by unscrewing the screws with a Phillipshead screw driver. After running the wires beneath these panels, you'll arrive at the very front portion of the car and an apparent dead end. Nevertheless, also for the trunk, the carpeting could possibly be pulled back to keep on concealing the wires. Don't let yourself be concerned about if you only pull out the fringe sections of the rug destroying the rug as it's readily re attached.
From here, you can use all of the necessary wires to the head unit. First, remove the head unit in the dashboard. Some folks will further remove portions of the dash to make room to correctly run cables to the top unit. However, with a straightforward trick can become a time saver. Use a broken coat-hanger to run wires up through the wiring channel supporting the head unit. Considerable time may be saved by this.
Find a difference within the automobile to operate the electricity cable from your amplifier to the battery.
Detailed info on VW Autoboxen can be found on the main website.
