Advice for upgrading my VW stereo system3126013
Izvor: KiWi
So you've got your amplifier, subwoofer, speakers and head unit for your Volkswagen. Now what? Installing a stereo in a car normally is not as daunting a challenge as it appears at first with those wires. In The Other-hand, some recommendations can help when approaching the job for your.
Pop the hood and disconnect the battery. Make certain you've properly disconnected it by examining your dash.
Cleanly installing a stereo to the vehicle is usually the trickiest and most timeconsuming parts of the setup process due to many wires running for the amplifier and head unit. About The Other Point., the is a simple car to run and hide wires through. Before beginning, be certain you understand the method to wire your amp, loudspeakers and head unit because that information can really save a real pain subsequently.
The baggage compartment is the most logical spot to situate the amp. The amp will definitely be screwed by many people towards the back of the rear seat to save space or just twist it towards the bottom of the trunk. Either way works fine.
The whole back seat folds down, creating a straightforward avenue to run wires through to the front of the auto. It's also where you'll need to ground your amplifier. Appear beneath the base seat cushions in the rear, you'll see the seat-belts are screwed in with a nut.
Open one-of the back doors and moreover you'll see a plastic panel to the ground. This is the area at which you'll need to stay on wiring your stereo. The same is true for the frontdoor. These black-plastic panels might be removed by unscrewing the screws with a Phillips head screw driver. After running the wires beneath these panels, you'll arrive at the very front part of the automobile and an apparent dead end. However, also for the trunk, the carpeting could be pulled back to continue hiding the wires. You shouldn't be concerned about as it is readily reattached if you simply pull-out the fringe sections of the rug destroying the carpeting.
From here, you can use all of the necessary wires up-to the head unit. First, remove the head unit in the dash. Some people will further eliminate parts of the dash to make space to correctly run cables to the top unit. However, using a straightforward trick can become a time saver. Use a broken coat-hanger to run wires up through the wiring channel supporting the head unit. This might save considerable time.
Locate a difference in the auto to run the electricity cable from your amplifier to the battery.
Detailed info on autolautsprecher für vw can be found on the main website.
