Advice for upgrading my VW stereo system7400092
Izvor: KiWi
So you've got your amplifier, sub woofer, speakers and head unit for your Volkswagen. Now what? Installing a stereo in a car generally isn't as daunting a challenge as it appears at first with those wires. In The Other-hand, some recommendations may help when approaching the job for the.
Whenever working on electrical devices, ensure everything is powered down to prevent hurting yourself. Pop the hood and disconnect the battery. Ensure you have properly disconnected it by assessing your dash. After the mileage counter is off, then the battery is off.
Cleanly installing a stereo to the vehicle is typically the trickiest & most timeconsuming sections of the setup procedure because of many wires running to the head and amplifier device. Before beginning, be sure you understand the approach to wire your amp, loudspeakers and head unit because that info can actually save a real pain subsequently.
The baggage compartment is easily the most logical area to situate the amp. The amp will certainly be screwed by lots of people towards the back of the rear seat to save space or simply screw it towards the trunk. Either way works good. The baggage compartment is lined with a substance which is easy to pare back to run wires through for the rear speakers in the event you must power these with your amp.
The entire back seat folds down, creating an easy avenue to run wires through to the very front part of the auto. It is also where you'll have to ground your amplifier. Seem underneath the bottom seat cushions in the rear, you'll see the seatbelts are screwed in by a nut. Use a Phillips head screw-driver to participate the grounding cable and unscrew the nut, then twist everything back together.
Open one of the back doors and moreover you'll see a plastic panel to the earth. This is actually the place at which you'll need to stay on wiring your stereo. The same holds true for your front-door. These blackplastic panels may be removed by unscrewing the screws using a Phillips head screw driver. After running the wires beneath these panels, you'll arrive at the very front section of the car and an apparent dead-end. However, moreover for the trunk, the rug may be pulled back to continue concealing the wires. Don't be concerned about if you simply pullout the fringe sections of the carpeting destroying the carpeting as it is readily re attached.
From here, you can apply all the needed wires up-to the head unit. First, remove the head unit in the dashboard. Some folks will further eliminate portions of the dash to make room to correctly run cables to the top unit. However, using a trick can become a time saver. Use a broken coathanger to run wires up through the wiring channel supporting the head unit. Considerable time may be saved by this.
Locate a gap within the auto to operate the electricity cable from your amplifier to the battery.
Detailed info on vw auto lautsprecher can be found on the main website.
